So I started making a set of earrings from wire and decided at some point to share a little.
first off, I had a ton of solder joints. All the bends in the wire i notched the wire, bent the wire then soldered in the notch to give it strength again. As you can see I used my tweezers as heat sinks to prevent certain joints from accidentally flowing. For the most part I was able to use hard solder, but the spot that had 4 joints at once I decided to use medium on. you can see in the picture below H for hard solder, M for medium. No need for easy.
I then put on the earring post with medium, again using tweezers to prevent that one joint from accidentally getting too much heat and flowing on me.
I then added the wires for the pearls and soldered them closed. I polished up the prongs so they were smooth.
I decided to try something so i oxidized the posts
And tumbled them so the oxidation became permanent....i might touch up a little to make the darker once they are set.
Aand this is what i got: black tourmaline and pearls. Super classy. I overworked one prong so i gotta re-solder it, then liver of sulfur, then tumble then reset. le sigh. Almost done, though. Hope it gives you some ideas how to solder lots of joints together.
